|
|
Posted by Bob Stopka in Panama City on Saturday, July 05, 2008 at 11:35:40 :
Hey all,
I have an Braden MU2A Winch setup for a flat fender power wagon that I would like to sell. This is updated information from the original post on the previous forum. It is the MU2A for a 230 CI set up, with front and rear winch brackets, and the side cast brackets which the winch shaft fits into. There is also the winch spool engage / disengage donut on the shaft next to the winch spool. These pieces are all assembled. Also included are two good 15 inch long frame extensions, and the correct pto shaft with u-joints on both ends. There are no split bumpers or bumper brackets, or cast declutch handle, but all these can be purchased repro. It is a pretty complete winch set up, and in good overall shape. It has been stored under cover in a barn for some years. If anyone is interested I expect to be able to email photos to you some time soon after the July 4th weekend. Asking $ 650.00 OBO delivered FREE to Green Mountain Power Wagon Rally in Cavendish, July 25th / 26th, or deliviered FREE anywhere along my route home to NW Florida around Aug 8th - 10th. My route home to NW Florida from Connecticut/Mass will basically be down I-81 via Scranton, Pa., and then from NE Tennessee south off I-81 through Ashville, NC, to Greenville, SC, then to Atlanta, Columbus, Ga, and back to Panama City. Am willing to deviate off that path a little to meet up with a purchaser. Can email photos some time soon after the July 4th weekend. If anyone is interested, give me a quick call on my cell at 850-624-6319, or email me at robert.stopka@hp.com and provide a phone number in your email and a good time to call you. For those who inquured during the last forum post, I will email the photos to you soon, when I receive them from my brother in Mass. Thanks, Bob Stopka
Follow Ups: