|
|
Posted by copey on Sunday, May 18, 2008 at 19:23:09 :
In Reply to: Master cylinder question posted by MoparMogSteve on Sunday, May 18, 2008 at 18:00:11 :
use a little care here > if you do drill the inlet?return hole you must disassemlbe the master cylinder first > remove the little chips thet might fall in the bore >then LIGHTLY hone the cylinder where you drilled > to remove any BURRS that will cut the rubber piston, seal > blow out with compressed air > then flush with brake fluid only > bleed it on the bench install and bleed it at the master where the line connects > hole size is not that critical >but i would stay under 1/16 ~J