Posted by Ricker on June 21, 2000 at 08:16:44:
In Reply to: 318 engine swap posted by jon in VA on June 20, 2000 at 22:26:04:
Its very do-able. Just remember that you will need to decide on one very important issue first- Are you going to keep the EFI?
If so, you will need EVERYTHING from the van- engine, computer, sensors, wiring harness, instruments, etc. Everything.
Then there is the issue of bolting up the magnum engine. Obviously, you'll need new mounts, maybe new front springs, and you'ld probably be better off changing out the tranny, radiator, and rear-end as well.
This is not impossible, but it's also not a direct bolt-in. The starter and flywheel aren't an issue. One more point is the Magnum engine mounting pads are not quite in the same place as the LA counterparts. An easy work around, just be aware of it.
Good luck with the project! It won't be easy, but it should be quite rewarding!