Posted by Eric B. on June 20, 2000 at 15:17:11:
For Sale:
All of these parts are in good shape and are very useable with a small amount of repair. Most parts have some rust (mostly surface rust), and there are small dents and dings.
Parts are located in MN near the twin cities, you pick up the big stuff, smaller parts can be shipped via Greyhound, buyer pays shipping.
If you have a question about any of the parts, or want to see pictures please E-mail me at ( townwagon@hotmail.com ).
There are also many other parts available, please E-mail with needs.
Cabs:
1941 2wd cab fits 1941-1946 no rust very clean, some dents, hole in roof from antenna, no windshield frame. $300 If needed I have a cowl to make this cab fit a WDX Power Wagon
1952 and later PW cab no rust good shape, with doors. $500
1955 2nd series 2wd cab, big back window, good shape, little rust. This cab has good front and rear glass.
W/O doors $400
With doors $600 (doors are in good shape, with all internals)
1956 2wd cab, big back window. Bare cab, with doors, some rust in floors $300. glass available.
1957 2 or 4wd cab, big back window, some rust in floors. With glass $460.
Doors:
1952-53 pair of doors for standard pickup, will separate $150 minor rust repair necessary
1961-66 Town Wagon or Town Panel drivers door, will also fit '58-60 pickups, has been repaired due to rust in the bottom of the door, no internals $50
2 1958-60 pickup or Town Wagon/Town Panel passenger side doors, just the bare skins. $50 each
1 set of rear doors for a Town Wagon/Town Panel, real rusty, the lower 3" of the inner skin is full of holes, outer skin in decent shape rust wise, and strait. $50 for the pair.
Bed parts:
1952-53 9 foot bed sides with front panel, decent shape. $250
1954-55 7 ½ foot bed sides with front panel, decent shape $150
1956-? 6 ½ foot bed sides with front panel, decent shape $200
Fenders:
Flat fender PW fenders, front, great shape $200 for the pair.
1954-57 2 pair front fenders 2wd good shape. $75 each
1954-57 1 passenger side front fender, good shape. $75
1954-57 several pair of inner fenders. $50 each
1953 and up driver side rear fender, ok shape $20
Core supports:
1961-66 Town wagon /Town panel core supports 1 strait but a little rusty, 1 not rusty but has a dent in the center. Will also fit '58-'60 pickups. $100
1957 core support, with chrome, some small dents. $100
Hoods:
Various years, mostly '54 to '60 but have other years. $75-$150
Running boards:
1958 and older 1 pair short running boards good shape, some small wear, no rust. $200 for the pair
B series 1 ton 2wd 9 foot box running board great shape $100
N.O.S body parts:
46-47 Left front fender for a 1 ½ ton $200
1936 Plymouth right front $200
1941-47 Panel Left Rear. $250
Gas tanks:
1940- 71 2wd gas tanks, E-mail with needs. $80-$120
Axles:
Various WDX-WM300 and M37 axles. $200-$300
30's to the 70's 2wd axles. $100-$300
'57-'70's 4wd axles. $200-$500
Also many axle parts, please E-mail with needs.
Transfer cases:
NP201 transfer cases, and various transmissions. $200-$300
Winch:
1960 W300M winch, with driveshafts, extensions and PTO still attached to tranny $1300
Engines:
WDX and up Engines $200 bare, $300 with ACC:
1949 T-137 Block and head only.
1952 T-137 long block, engine turns.
1953 T137 Long block, Engine turns
Car and truck flat heads:
1933 Chrysler L6, engine turns exhaust is cracked $150
1947 Dodge ½ ton L6 engine turns, all ACC. $300.
1954 Chrysler L6 engine runs, spitfire, $200.
Whole trucks:
1957 W200 V8, #11 of production that year. 7 ½ foot bed. Project truck very good parts.
1958 W200 L6, NP420, 7 ½ foot bed Project truck, very good parts
1962 W100 Town Wagon, Body rusty, needs new front floors, and repair to the front fenders. The drivetrain is in good shape, and the brakes are new. The truck runs and drives.
Poly 318, NP420 4sp, NP201 transfer case, Dana 60 rear, Dana 44 small knuckle front.
This truck has an original PTO winch with all the parts, winch works well.
$4,500 with the winch
$3,000 without the winch.
Several other trucks for sale, please E-mail with needs.