Posted by Vaughn on June 19, 2000 at 10:49:42:
In Reply to: Rear belt drive schematic needed posted by George on June 17, 2000 at 20:17:32:
If your truck is the old style power wagon, you should have:
Front
- Half moon woodruff key
- Yoke, universal joint and front drive shaft that connects to the PTO (79&1/2 inches long);
Center Bearing
- Center bearing housing;
- 2 center bearing spacers (1&1/4 inches long)that go on each side of the center bearing housing;
- Steel half moon retainer that bolts to crossmember to hold center bearing;
- Rubber insulator that goes around the housing to insulate housing from retainer
Rear Shaft
- Yoke, universal, shaft (44&5/8 inches long)
- Half moon woodruff key
Match bolts up to pieces.
Sorry, no schematic
If you need bearing numbers or seal numbers to replace old ones, let me know.