Posted by Mark K on Sunday, August 05, 2007 at 17:38:35 :
I'm working on a high power poly engine for my PW, but my clutch will never hold. When I put in a new clutch a few years back, the only thing I could get was rebuilt disk and rebuilt pressure plate and they weren't very good. Bone stock, with a carter 2BBL, with a trailer on behind, you can get it to slip a little too easily.
Since what I'm working on will likely have torque that will exceed 350 ft-lbs, the stock clutch is simply not going to hold.
Does someone out there have some ideas on this?