Posted by mike stone Idaho (aka COTWM) on Tuesday, June 26, 2007 at 16:14:20 :
In Reply to: You are right more or less posted by wet coast bruce on Monday, June 25, 2007 at 21:59:53 :
backside is from the mounting flange to the
outside of the rim flange
put sraight edge on the rim & measure down to
the flange
if the wheel has a tire on it then put the straight edge across the tire, measure to the
flange, then measure from the tire to the rim flange and subtract this amount
rim width is bead seat to bead seat inside