Bending rectangular tubing

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Jerry in Idaho on Thursday, March 01, 2007 at 19:49:06 :

Is there any way to bend 1 1/2" or 2" x 6" rectangular tubing at a 45° angle without the edges bulging out? I would like to use rect. tubing for the front bumper on the W300 I'm putting the winch on. Thanks. JH

W500 in snow

Follow Ups:

Build one that looks like this - wet coast bruce 01:14:12 03/02/2007

Re: Bending rectangular tubing - Jerry in Idaho 23:07:25 03/01/2007

Re: Bending rectangular tubing - MoparNorm 02:29:50 03/02/2007

Re: Bending rectangular tubing - Dan Shockley 20:23:13 03/01/2007

Re: Bending rectangular tubing - Jerry in Idaho 00:39:40 03/03/2007

Re: Bending rectangular tubing - Pieter 20:12:09 03/01/2007

Re: Bending rectangular tubing - Jerry in Idaho 00:32:56 03/03/2007

Re: Bending rectangular tubing - Paul Cook in Kempner, Texas 20:04:55 03/01/2007

Re: Bending rectangular tubing - Jerry in Idaho 00:37:41 03/03/2007

Re: Bending rectangular tubing - Bob Thompson 19:58:35 03/01/2007

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com