Posted by Roger in La on Sunday, February 04, 2007 at 13:50:09 :
In Reply to: Pinion yoke removal posted by Roger in La on Saturday, February 03, 2007 at 19:20:25 :
Used a steering wheel puller and used the center screw to push against the u-joint clamps.
It was very tight, even started chewing the end off the puller screw when it finally started to move.
It wasn't corroded when I got it off. I think the last guy put lock-tite on the shaft threads and it got into the splines is all I can figure.
Anyway, I changed the seal and it put it back together. The seal was easy to get out compared to the yoke.
Thanks for the advice, Roger
Follow Ups: