Posted by METALMAN on April 03, 2000 at 16:52:18:
In Reply to: rear wheel studs posted by travis simpson on April 03, 2000 at 02:24:22:
The Square is 13/16. Proto makes it in a impact socket.Put the old gas wrench to the studs + heat a bit, let cool + put the penentrant to it then try to loosen with breaker bar with the shortest ex you can or use a truck 4 way supported by a jack stand opp stud end + 2 handed even pressure.If it dont loosen heat again + try .Make sure you are going the right way also.There are R or L hand studs L hands are usually goldish in color or have a L on the square.I have seen the square break off then its vise grip or Ken Tool time as they make a special tool to remove broken Budd studs.Take your time WEAR SAFETY GLASSES + WORK SAFELY + REMEMBER RUST NEVER SLEEPS