Posted by Paul (in NY) on Wednesday, December 13, 2006 at 17:35:30 :
Since PW/Carryall fenders are difficult to find, I have been looking for options. I did a lot of measuring and determined that M37 rear fenders are 'very' close. With a high degree of confidence, I bought 4 NOS M37 rear fenders this past week. If you put two together as in the picture the overall width is .375" narrower than a PW Fender, arc is the same. I clamped the M37 fender on the Carryall and PW, with the front even. In both cases the M37 fender is about 3 inches longer than the PW/Carryall. This will allow for sculpting the rear to match the round edge of the original PW/Carryall fenders. The M37 Fenders have the nice rolled edges with the wire just like the PW/Carryall fenders. The resulting fenders made up from M37 fenders will be very close to the originals. However for a Show Truck, this is not the way to go. Its my feeling that after some cutting for length and sculpting the rear, it will be difficult to tell from originals. This is NOT Plug and Play, you will need to do some work to make them look like originals, but it can be done. I will be using M37 fenders to make rear fenders for my Power Wagon Swivel Frame.
Paul
Follow Ups: