Posted by Peter Gillies on Tuesday, September 05, 2006 at 8:55AM :
In Reply to: Rebuilding wheel cylinders ?'s posted by Todd Wilson on Monday, September 04, 2006 at 11:41PM :
Todd
Where you might find a problem is obtaining new rear wheel cylinders, if yours cannot be cleaned by honing. They are a stepped bore ( 1 3/8" & 1 1/2".) I have had no success at all finding these items here in Vancouver, nor in any of the calls I have made into the US. The front wheeel cylinders are a 1 3/8 & 1 1/4 which are the same as the PW and obtainable. Should you happen to find rear ones at less than $100 a piece form some vintage auto supplier please let me know. Best of luck Peter
Follow Ups: