Posted by Tim Holloway on Monday, August 28, 2006 at 7:07PM :
In Reply to: Re: Hey Dave Hibbard... posted by Dave Hibberd on Monday, August 28, 2006 at 6:36PM :
Hi Dave,
The washer isnt threaded, probably just used to being there. I would give it a couple of taps and it should pop out of there.
When using the puller, dont expect the wheel to come off as you tighten the screw down. It might, but not usually. After tightening the screw, with an impact wrench if possible, give the hex end of the screw a couple of sharp raps with a decent sized hammer. Then the wheel should pop off into your lap. Havent had one say no yet!
Good luck,
Tim