Posted by Joe Cimoch on Wednesday, July 26, 2006 at 11:07PM :
In Reply to: cowl light placement posted by billy-jay on Tuesday, July 25, 2006 at 10:13PM :
Answer from a few years back:
I'm putting a set of cowl (parking) lights on the '68 WM300. Cowl lights didn't come on the '68 so I need some dimensions to drill holes to get these installed. Two measurements should do it. One up from the seam where the body panels meet. and one from the front or back of the panel where these go. Or anything else that works.
: Joe
Joe,
Wish I had a scanner, but here are the measurements
off of 51 cab. From body seam below lights, holes
are 1 1/2" (seam to center). From edge of door, rear
hole is 3 9/16" to center, center hole is 4 3/4"
to center, and front hole is 5 1/2" to center.
Front and rear holes are 1/4" and center hole is
1/2". Make a template with a piece of matboard or
equivalent and compare to hole and studs on cowl
light cups.
Hope this is some help to you.
-Dallas
Follow Ups: