Pitman arm position Picture

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Paul (in NY) on Friday, June 23, 2006 at 8:54PM :

In Reply to: Re: Are you measuring the taper? posted by Dan H on Friday, June 23, 2006 at 8:01PM :

The ball on the pitman arm points to the frame on my Stock PW. The Saginaw Box used is a Mid 70's Dodge. The Pitman arm matched the output shaft/spline perfect and tightened right up.

I never measured the diameter of the ball.

Paul

Friends Dodges

Follow Ups:

a stock 1/2 ton wc one is a fit - mannyc 10:17PM 06/23/2006

Re: a stock 1/2 ton wc one is a fit - Kaegi 11:15PM 06/23/2006
- Re: a stock 1/2 ton wc one is a fit - Dan H 11:19PM 06/23/2006
  - Manual nm - Kaegi 11:54PM 06/23/2006
Good Info Manny, Thanks ntxt - Paul (in NY) 10:44PM 06/23/2006
Re: a stock 1/2 ton wc one is a fit - mannyc 10:17PM 06/23/2006

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com