Posted by PittMan on Thursday, March 23, 2006 at 2:13PM :
In Reply to: Re: I'm going to take a brake break! posted by Kaegi on Thursday, March 23, 2006 at 12:32PM :
I have a heavy wall glass vessel that will hold about 2 quarts. I use it to pressure treat wood for knife handles. I can attach a 1/4 in. hose to it to dispense the fluid. I suppose I can make a lid for the master cylinder with a 1/4 in. inlet. The lid is a bolt-down so a piece of aluminum with a gasket, and a groove ground in it to allow fluid to pass between the front and rear chambers should suffice. How much pressure should it require?
Follow Ups: