Posted by Todd Wilson on Tuesday, February 28, 2006 at 3:20PM :
In Reply to: Strippers(Paint that is) posted by Judy Cushing on Tuesday, February 28, 2006 at 8:00AM :
Why dont you do it the old fashion way and use a DA sander and sand the paint off by hand. No worrys about chemicals or pitting/warping of the sheet metal from sand blasting. Chemical strippers if not cleaned up and gone will damage your new paint. Sand or abrasives will pit the metal and or warp it from the heat. If this stuff lands in a nook or cranny it will trap moisture and start the rust out process only to be found later on after things are done and painted.
Go to the farm store and buy a cheap DA sander and find you an automotive supply store and buy you a roll of cheap 40 or 80 grit DA discs and go to work. You will know every inch of your vehicle when you are done.
Todd