Posted by mannyc on Tuesday, January 24, 2006 at 4:52PM :
thanks for the responses below. I might not have explained the situation clearly. on my 3/4 t command car, the selectros were installed with studs. the splined inner portion of the hubs do not bind and the axle is not twisted. the holes in the hubs are extremely tight on the studs and installing the hub was accomplished by using the nuts to pull it into place. getting the hub off required me to use a pipe wrench to take out enough studs to remove the hubs. using a pipe wrench (double nutting didn't work) ruins the studs and im wondering if someone had this problem before. in addition, im wondering what problem there would be if i used hex head or allen head bolts instead of studs. thanks again, mannyc
Follow Ups: