Posted by Willy-N on Tuesday, January 24, 2006 at 1:08PM :
In Reply to: Make and sell paper templates from the kit that you have. NTXT posted by Mark in NJ on Tuesday, January 24, 2006 at 0:48AM :
Just use a 4 ft wide peice of card board about 12 inches deep. Remove the front trim metal and trace the pattern and cut the card board to fit it. Measure from the center point all the way back to below the rear window and cut the 4 ft wide sheet that long. You can use the holes in the trim section to mark out your pre/drilled holes in the sheet. Temporaly mount the front push it up and you can find the rear window top. Take the rear window trim center it on the peice and mark it out for the cut and also mark the trim holes for the pre/drilled holes, they will all line up using a Pointed Object thru the holes to line them up into the Bodys holes. Just do not make the screws tight till you have them all in. I used stainless steel screws but also used 1 inch ones temporarly to hold it in place and replaced them after I got them all in. It allowed the sheet to line up better to get the short ones in. Finding the hole in the body was easier with the longer screws first. Mark H.
Follow Ups: