Posted by Tim Holloway on Wednesday, January 18, 2006 at 7:42PM :
Getting the Poly set up to start on a stand. The battery cables are connected and I have a remote starter button for cranking. All that is fine. I ran a wire from the pos terminal of the battery to one side of an on-off switch. The other side of the switch to one side of a ballast resistor. Other side of ballast resistor to the positive post on the coil. Negative side of coil to distributor.
Coil, wires, cap, rotor, condensor and plugs are all new. I get power to the points but nothing coming out of the HT coil wire. We are not talking rocket science here, I am flummoxed!
Thanks,
Tim
Follow Ups: