Posted by Scott R on Thursday, December 22, 2005 at 3:18PM :
In Reply to: Power Train Combo? posted by Larry On Hood Canal on Thursday, December 22, 2005 at 7:22AM :
Larry, I did use the Heli tool set up for the engine mounts. The front mount is different than what Ray had in his site, it's a one peice unit that bolts to the front, through the timing cover, etc. Not sure if you can still get one or not. The Trans. is a NP 435 (wide ratio) bellhousing is the same as what Ray talks about in his site. I was able to pull the whole works from a doner truck.
Trans. case is stock NP 200. the PTO thing is out the door, I could not come up with a good 435 with duel windows, so I will drive my winch with a Hyd. motor. I have a full system on board, so this will be an easy set up.
My Poly is 60 thou. over making it a 327. It's a squeeze :)