Posted by jerry on December 12, 1999 at 11:29:44:
I was hoping that either Charlie or someone else can answer this. I'm putting a coil over setup on the front end, when you guys have talked about4 to 5 degree's does that mean that you are turning the pinion to point "DOWN" or does it point "UP." I'm going to run a CV-Joint on the front driveline if that matters.Also I'm taking my measurment by putting the protractor on the end of the pinion yoke, is this the right spot to measure at? The front end is a old style closed knuckle if that matters... "4 deg up "OR" 4 deg down". Thank's for the help!