Posted by COTM Mike Stone (Idaho, USA) on Friday, July 22, 2005 at 5:19PM :
In Reply to: Re: I have no Idea but to be safe you might posted by Dana in Ma on Friday, July 22, 2005 at 3:31PM :
do you know what the 10s came off of ?
with that you might be able to determine the
capacity & compare with OE PW
regards the angle braces you might be able
to find a machine shop that has a Rockwell
tester and perhaps there is one in Fairfield
that VPW could get the OEs tested
non-destructive quick test to find out what
you have
Follow Ups: