Posted by moby on November 02, 1999 at 12:35:16:
In Reply to: Use a pipe section posted by Winget on November 01, 1999 at 08:39:25:
I tried the pipe thing but the alt. pulley did not line up with the other pulleys all that well. The wires go like this: I took the voltage regulator out completly (since theres a internal one in the alt.) and ran the wires through the raido filter. The battery wire of course goes to the positive battery cable. The #1 goes to the ignition switch then to the coil. The #2 wire goes to any keyed on hot wire. I just put it to the acc. post on my ignition switch. I guess I should mention I am using a 3 position keyed ignition switch that I also got from NAPA. so far everything works fine.