Posted by COTM Mike Stone - down the road from ken on Tuesday, June 21, 2005 at 11:21PM :
In Reply to: Ken Sterrett posted by Dylan on Tuesday, June 21, 2005 at 3:51PM :
rebuild costs depend upon a number of factors
1. where are you located ? hourly machine shop rates vary greatly well over 125 hr or
higher in some areas
2. what are they doing ? what do you mean by
nose cone?? - the cast front bendix housing?
cost me about 100 bucks in Twin Falls a few years ago to have the starter on my 48 gone
thru (6volt) special brushes for 12volt,
new switch, bushings, & armature turned
check and see if VPW has one