Posted by Bruce in sunny Sechelt on Friday, June 03, 2005 at 10:46AM :
In Reply to: Anything I should know before I posted by Matthew - Nebraska on Friday, June 03, 2005 at 9:31AM :
Step one - remove the rear cap and bearing
Step two -rotate the crank shaft until the oil hole shows in the main journal.
Step 3 put a small piece of brass in the oil hole tocreat a dowl that sticks out just far enough to touch the top bearing half.
Step 4 - rotate the crankshaft-DO THIS IN THE RIGHT DIRECTION !!! _ the index tab needs to rotate out not in. If it goes in you can create a mess.
Bruce
Follow Ups: