Posted by chris case on Sunday, April 17, 2005 at 5:11PM :
In Reply to: Re: hand crank starts posted by Katzbalger on Sunday, April 17, 2005 at 4:27PM :
3/4 cold rolled steel, 3/8 pin about 1 1/4 from end. Pin has to fit through radiator hole. Stick it in, turn it with vise grips or pipe wrench (hope to clock it so the pin will be near the plane of the rest of the crank)until compression is felt, bend it at the 7:00 position (heat red hot), bend again at 8 inches, saw off excess. Smooth ends. Go yank your crank.