Posted by Paul (in NY) on Wednesday, February 16, 2005 at 7:04PM :
In Reply to: Re: How I did My Warn Hubs posted by Tim Holloway on Wednesday, February 16, 2005 at 3:14PM :
you tear down the hub, look in the top half. You will see two screws 180 degrees apart. These screws are staked with a punch when inserted. You can easily remove the small staked portion and remove the Brass rotary control. I found mine full of old grease and dirt makeing them hard to turn. There is also a Quad Ring inside. I was unable to locate a Quad Ring, but found a nice fitting O ring at NAPA that fit perfect with no grease leaks.
Paul