Posted by Willy-N on Wednesday, December 29, 2004 at 11:24PM :
In Reply to: Re: Seat Question Again... posted by WC Rick on Wednesday, December 29, 2004 at 2:07PM :
The S10 fits I put it in my Power Wagon. You need to make brackets for it but you can use angle iron and bolt to the exsisting seat mount if you make it right and not mess it up for a stock seat later. Just rund 2 - 2 inch angle iron one on front and one on rear of the seat base then cut you mounts for the new seat to fit mark it out unbolt the angle iron weld it up and put the seat in as one assembley. You can still make the seat go back and forth if you do it right. Mark H.
Follow Ups: