Posted by Giles on Sunday, December 19, 2004 at 9:50AM :
In Reply to: Drill Doctor posted by John on Friday, December 17, 2004 at 10:01PM :
I am a tool and die maker--I can't see well enough to sharpen small drill bits so I purchased a drill doctor for over $140. The chuck is "mickymouse" If you buy one or can try one, do this---insert the bit exactly as instructed and look at the drill "shank" alignment. It will be off set, not exactly in line with chuck centerline, a very small amount. This will not yeald a correctly sharpened point. I called the company and they supposibly were not even aware of he situation. I guess they laughed. I took it back and bought new drill bits instead for a lot less money.