Re: Need to Vent


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Bill J. (El Paso) on Saturday, October 16, 2004 at 1:37PM :

In Reply to: Need to Vent posted by Dan on Saturday, October 16, 2004 at 12:49PM :

Dan,
I had a fuel pump where the pin kept sliding out so I finally ground an 1/8 of an inch off the end of it so that once I installed it back into the body, I could peen over the ends of the pin so that it would be impossible for it to slie back out. If you need to work on it in the future you just need a small punch to push the pin back out. Hope this helps.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com