Posted by Steve Elliot on Wednesday, July 07, 2004 at 8:25PM :
In Reply to: Re: bronze axle bushings posted by KenW on Wednesday, July 07, 2004 at 10:59AM :
I thought about putting a spiral lubtication groove in the bushing. It would'nt hurt anything. I also wonder if one were to not install the oil seal that goes next to the bushing then the diff lube could travel to the bushing. If it got past the bushing then it would mix with the grease in the tracta joint so maybe that's not a good idea. However while the bushing is new it would be hard for 90 wt oil to get past the bushing. If the bushing did get lubricated in this way it should extend its life. Anybody have any thoughts on this?
Steve
Follow Ups: