Posted by Tom J. on Monday, July 05, 2004 at 8:50PM :
In Reply to: ffpw axle bushing posted by Steve Elliot on Monday, July 05, 2004 at 5:56PM :
I made a puller from all thread and ground the sides off of some washers with over sized center holes so, they could be slanted to slide through the old inner bushings, using a piece of flat or agle iron on the outside of the knuckle and it came right out. Then I made a nice little installer from a foot long piece of oak hand rail. I sawed and wittled it to fit perfectly into the bushing and then drove it and the seal right in.....