Posted by Dan on July 12, 1999 at 22:35:41:
In Reply to: Reproduction parts posted by Ray at Helitool on July 11, 1999 at 12:51:17:
Ray:
I would like to see you reproduce rear axel shafts for the power wagons and m37s.I feel there is a strong market for them, especially with so many people doing engine conversions. Even at a cost higher than nos , it would be cheap insurance against axel failure. I would also suggest repreduction beds and tailgates for the pw. As you are aware, there are three series of beds and that could run up tooling costs. Again, there should be a strong demand for this type of sheet metal as there is only a limited supply out there and most of it is very rough. I would love to see you develop the beds and tailgates and I'm sure that a lot of people running flat beds would convert to pu beds if the supply was there.PS Your disc brakes went on the front end with no problems - excellent work!