Posted by OTM mike (in Idaho) on Wednesday, May 19, 2004 at 10:48PM :
In Reply to: Something wierd going on here posted by Tyler on Wednesday, May 19, 2004 at 10:17PM :
tyler
read this carefully and follow instructions
you should take your cylinder head and the old gasket (after you have it removed) to a machine shop to have it checked to make sure it is flat (if not it will need to be machined)
they will probably be able to tell by the old gasket where the problem is/was
VPW will probably have the correct head gasket if not Kanter.com (Kanter Auto parts
has them)