Posted by Dwight in Ft.Worth on Sunday, May 16, 2004 at 1:04PM :
In Reply to: bench seat posted by eds on Sunday, May 16, 2004 at 10:44AM :
Early 90's Dodge Dakota seat in my 49.
I used a 1/2" piece of plate cut to the contour of the bottom of the seat and drilled holes in it where the factory pins would stick thru. Made up some blocks out of a piece of pipe to get the hight and pitch of the seat I liked, welded them onto the piece of plate where the seat bolts down(new seat boltholes) and then drilled holes in the bottom for long bolts to go up thru and bolted the new seat to the plate and set it in place.
Follow Ups: