Posted by Keith in Washington on Friday, April 30, 2004 at 3:01PM :
In Reply to: Dent removal tips? posted by Dwight in Ft Worth on Friday, April 30, 2004 at 2:39PM :
People have run a rod through the tube and applied a little heat to the dents as the rod approaches the ding. You could do the same for the bow. For the dings I use a spot welder that puts a small wire tab on the sheet metal. I then use a slide hammer that is designed to grip the wire tab and lightly pull the ding out then grind off the metal tab. They sell these kits for about $300 but are worth their weight in gold. I have done a lot o body pannel pulls with them.
Follow Ups: