Posted by Steve Elliot on May 06, 1999 at 17:05:22:
In Reply to: Winch U-Joints posted by Don M. on May 06, 1999 at 00:01:27:
For those of you who are machinists or who know machinists you can use the Napa # 853 if you grind the posts and the caps down the appropriate amount to get it to fit in the yoke. I did it with a surface grinder and it was not difficult. I think I ground about .030 off of the end of each post and cap to get the right length from cap to cap. By the way I paid about $30 for the Napa # 853. That's in California. Seemed high to me. If you had to pay somebody to do the grinding then it might not be worth it.
Steve