Posted by Chris In Idaho on Thursday, November 06, 2003 at 6:04PM :
In Reply to: Re: third member tool posted by Marty on Thursday, November 06, 2003 at 5:45PM :
I used a galvanized pipe coupler and then welded 4 thick beads and ground them down to fit. Then welded a 1/4 inch piece of steel to the top and drilled then filed a square hole on the top through the steel plate so that I could put the end of the air tool in and it came right off no problems. I can now use a regular ratchet to put it back in/on. Not the prettiest tool in the world but I'm proud of it and it worked. I'll sell it for $100 hahaha
Follow Ups: