Posted by Tug Boat Lonnie on Monday, October 27, 2003 at 5:31PM :
In Reply to: Re: 12 volt problems posted by Tim Holloway on Monday, October 27, 2003 at 5:17PM :
Sorry, been up too late, yes you should see 12V everywhere after the conversion, but I have seen things installed in series act as voltage dropping resistors. What I should have said is, just check to see if you have 12 volts at the device. If it is less than 12 volts, just work your way back to the source,
Best Wishes
Lonnie