Posted by Don on April 14, 1999 at 17:46:29:
In Reply to: Winch Drive Shaft Wanted posted by Tom on April 14, 1999 at 10:33:37:
Maybe you could make your own, I did, using Spicer parts,
Winch shaft yoke SPICER# 10-4-443
PTO yoke SPICER# 10-4-103
(2) Shaft yokes SPICER# 10-4-193
(2) U-Joints SPICER# 5-170X
6` pto shaft round and keywayed SPICER# ???
I made this in 1985 and I can`t find the shaft number, but if your Spicer dealer has these yoke numbers he will know what shaft size, I think it is 1 1/8". You can check this out and see how much it will cost you then you`ll know which way to go. Hope this helps,
Don