Posted by mike stone on Thursday, May 15, 2003 at 8:58AM :
In Reply to: I hate working on kingpins posted by Dave Jensen on Thursday, May 15, 2003 at 1:55AM :
king pin bushing replacement is no problem
if you have the correct tool C-328A
dodge truck shop manual has detailed howto
along with photos
it is usually only the bushings that need
replacement not the actual pin
unless the bushings are worn so bad that the pin wore on the spindle then it is replace spindle time. and if the problem is as bad as described where the vehicle was not moveable then this is probably the case