Return to Website

SWEPTLINE CD's $20 Check or Money order to:James Megee1483 Perkins LaneEdgewater Park NJ 08010 or Paypal to: jmegee57@hotmail.comSee the CD page at http://www.olddodges.com/sweptlinecd.htm

61-71 Glove boxes, Core Support/Radiator seals, 69-71 Tool Stowage Decals, 69-71 Firewall Insluation Pads, and A100 glove boxes.Contact Gary Offill for pricing and info at gwo1988@yahoo.com
  
The '61-'71 Dodge Sweptline Truck Forum #32

The Official Forum of the DTA. Here's your place to talk about Dodge trucks made from 1961-1971. The Truck of The Week belongs to Craig. To view the DTA Photo Albums, click on the "Return to Website" link below. To view DodgeSweptline.Org, click on "DTA HOME"  Best viewed in 1024x768 Not affiliated with Chrysler LLC. Dodge is a registered trademark of Chrysler LLC

      


Return to Website

  Reply
  Home

Subject:   Re: Re: hubs/rotor problem
Name:   pat
Date Posted:   Jul 18, 08 - 9:26 AM
IP Address:   24.75.45.43
Email:   dahooligan36@yahoo.com
Message:   I don't think the problem is in the rotors as much as it is the hubs themselves.Article says may have to turn them down and as if some may already fit. I'm thinking there was different sizes on the hubs.Mark at scarebird also knows and is working on so I'm guessing there were other people with this problem.On mine the gap is a good 1/4 inch.I also checked the premire(better) rotors at NAPA and the same thing.I'm taking some shim stock and centering the hub/rotor on the back side and will drill through the tapped holes in rotor threw hub and use bolts from the backside into the rotor to center,once wheel lugs tighten that should hold everything in place.Also bolts into rotors are 7mm harden..................pat
Replies:    
Re: Re: Re: hubs/rotor problem by Lariet · Jul 18, 08 - 10:09 AM
Re: Re: Re: Re: hubs/rotor problem by pat · Jul 18, 08 - 5:28 PM


  Reply
  Home


powered by Powered by Bravenet bravenet.com