Return to Website

SWEPTLINE CD's $20 Check or Money order to:James Megee1483 Perkins LaneEdgewater Park NJ 08010 or Paypal to: jmegee57@hotmail.comSee the CD page at http://www.olddodges.com/sweptlinecd.htm

61-71 Glove boxes, Core Support/Radiator seals, 69-71 Tool Stowage Decals, 69-71 Firewall Insluation Pads, and A100 glove boxes.Contact Gary Offill for pricing and info at gwo1988@yahoo.com
  
The '61-'71 Dodge Sweptline Truck Forum #38

The Official Forum of the DTA. Here's your place to talk about Dodge trucks made from 1961-1971. The Truck of The Week, by popular demand is in Memory of 'Ugg'. To view the DTA Photo Albums, click on the "Return to Website" link below. To view DodgeSweptline.Org, click on "DTA HOME"  Best viewed in 1024x768 Not affiliated with Chrysler LLC. Dodge is a registered trademark of Chrysler LLC. The DTA is not responsible for views and suggestions posted here, use them at your own risk.

      


Return to Website

  Reply
  Home

Subject:   Hard to do this by keyboard without photos...
Name:   MoparNorm
Date Posted:   Feb 8, 09 - 2:28 PM
IP Address:   71.104.149.239
Email:   Click here to Email
Message:   ...but if the issue is just the ability to properly rotate the distributor (is it a new Mopar Distributor that is pinned or locked on number 1 from the factory?) then you can re-install it in any orientation as long as the rotor remains aimed at the number 1 wire hole.

The carb may need a jet change, remember that those adjusting screws are air not fuel.
I was really impressed with the new Edelbrock that we put on FrankyB's Poly, it was almost perfect out of the box, just a tad bit of fine tuning was required.
The displacement size of a motor is more important than cam design for the proper sizing of the carb. The 750 will work, but it's a monster carb with plenty of power for drag racing, not real practical for fuel economy.
I'd be willing to bet that a Poly can beat that 360 and give better fuel economy. So get her running so we can find out
Replies:    
Read your initial post again... by MoparNorm · Feb 8, 09 - 2:32 PM
Re: Read your initial post again... by GaryO · Feb 8, 09 - 7:10 PM
Re: Re: Read your initial post again... by MoparNorm · Feb 8, 09 - 7:59 PM
Re: Re: Re: Read your initial post again... by GaryO · Feb 8, 09 - 8:31 PM
Mopar Crate motor pics by GaryO · Feb 8, 09 - 7:12 PM
Re:Settle down Norm haha. by George(AB) · Feb 12, 09 - 3:43 PM
Re: I'm 20 degrees off in timing? Someone explain this to me. by dakota dave · Feb 12, 09 - 2:01 PM
Re: I'm 20 degrees off in timing? Someone explain this to me. by dakota dave · Feb 12, 09 - 2:03 PM


  Reply
  Home