Re: Front Lock out hub question. B-1 48 PW


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by chewie on Sunday, December 08, 2002 at 11:07AM :

In Reply to: Front Lock out hub question. B-1 48 PW posted by Willy-N on Sunday, December 08, 2002 at 10:56AM :

For the ring and pinion: Divide the number of teeth on the ring gear by the numbr of teeth on the pinion. Should either be a 4.89 or 5.83.
For the truck: Jack the rear end up. Mark a spot on the driveshaft and a spot on a tire. Spin the tire one revolution while counting the number of driveshaft revolutions. Once again, either 4.89 or 5.83.
Good luck!



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com