Posted by Clint Dixon on Thursday, December 05, 2002 at 5:16PM :
In Reply to: Re: rear drive pulley posted by EdC on Thursday, December 05, 2002 at 12:53PM :
Ed, as Dan mentioned, the beltpulley bolts to the pillow block, which in turn bolts to the same wellnuts that the pintle hitch mounts to. Not all Ford 9N-2N-8N beltpulleys have the correct spline to fit on the Power-Wagon pillow block. Most fit a 1-1/8" diameter shaft rather than the larger 1-3/8" Power-Wagon shaft. Not sure when Ford changed their tractors to the larger shaft size. But, it was done late enough that belt powered equipment was on the way out, so these pulleys with the larger spline are rare.
The bolt pattern on the mounting feet of a Ford pulley is the same as the bolt pattern of the mounting face of the Dodge pillow block. The two work together good.
I do not have any information on the model numbers of these Ford pulleys.
Clint