Problem identified--is there a solution?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Gil Huguley on Sunday, July 28, 2002 at 9:20PM :

In Reply to: NV5600 to '93 Cummins posted by Gil Huguley on Sunday, July 28, 2002 at 3:59PM :

Ok, I measured everything about the input shaft EXCEPT the length. The input shaft on the NV5600 is identical as far as pilot stub, shaft diameter, spline count, etc. but it is about one and an eighth inch longer. Thus the input shaft bottoms out in the flywheel before the bell mates up to the block. I will need to replace the input shaft with a shorter one. Anybody know a good shop with a parts guy who is intimately familiar with the NV5600 and patient also?
Thanks

Follow Ups:

Re: Problem identified--is there a solution? - Timmy 11:05PM 07/28/2002

Re: Problem identified--is there a solution? - chad 10:02PM 07/28/2002

Re: Problem identified--is there a solution? - Ryan in BC 3:58AM 07/29/2002

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com