Posted by Dave Maher on Thursday, February 28, 2002 at 11:59PM :
In Reply to: Re: Bed Tooling - Follow-up posted by Joe Cimoch on Thursday, February 28, 2002 at 10:28PM :
It's a 60-ton hydraulic Accurpress model, needing additional supports/procedures to make it perform as it wasn't designed to do!
But, "been there, done that" applies here! The tooling itself weighs about 2700 lbs., and questions arise as to whether it's "massive" enough! Fear not - "Yankee Ingenuity" is at work here, and I'm sure we'll work out the bugs in short order!
Dave Maher
Follow Ups: