From the VPW 6 to 12 kit....


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by bruce in CO on Sunday, January 27, 2002 at 9:56PM :

In Reply to: wdx 12 volt resistors posted by jim on Sunday, January 27, 2002 at 9:02PM :

...In place of a resistor for the 6V horn, VPW provides a replacement 12 V horn. The resistor for the fuel gauge says, "DALE RS-5 22 ohm 1% MEXICO M0013." It is a simple black cylinder about 7/8" long and 1/4" diameter with small-gauge connecting wires sticking out of each end. It goes between the "G" terminal on the fuel gauge and the "F" terminal on ignition switch with a 12 gauge blue wire. The ignition resistor is less descript as far as numbers. It only says "MEXICO D. PAT. NO. 254186." It is a brass coiled resistor encased in a 3" long porcelain shell which has a single hole for a screw/bolt mount. It has flat tabs for wire end connections. It goes between the "+" terminal on the coil and the "C" terminal on the ignition switch with a 14 gauge red wire. Good Luck, Bruce >



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com