Posted by Clint Dixon [172.68.90.97] on Friday, February 09, 2018 at 13:12:10 :
In Reply to: Re: Anyone know the PN for pinion seal? posted by Joe Cimoch [172.68.65.237] on Friday, February 09, 2018 at 11:11:42 :
Thanks Joe. If my list is a fabulous seal table, it is only because of two fabulous sites - the one hosting the information, and the one where the information is most commonly referenced!
I do have all of the CR catalogs also but I stopped short of including the CR numbers in the table because of personal preference. I have not had as good of results using CR seals as I have had with the National seals. The CR seals are narrower in almost all cases as shown in the sample in your data (0.313 CR vs. .375 National) and seem to be lighter duty based upon unscientific seat-of-the-pants testing. Although, I will admit that I have taken advantage of the narrower CR seals when I have experimented with doubling them up by installing two seals in a bore in place of a wide original.
Thanks for the interchange link.
Junior